<div>Hi everyone, </div>
<div> </div>
<div>I'm going overseas for around 6 weeks starting from the 10th of September, so this Sunday will be basically the last time I can work on the boats before the beginner courses. So if someone can come and give me a hand it will be very appriciated. I'll be at the shed this Sunday 29th of August, starting from 12.30.<br clear="all">
</div>
<div>What we'll need to do:</div>
<div> </div>
<div>General use lasers.</div>
<div>1. Distribute refreshed duggerboards between the boats.</div>
<div>2. Cut a few rubber washers for laser's bungs.</div>
<div>3. Check general lasers rig and replace ropes if necessary and cut some spare lines. </div>
<div> </div>
<div>General use tasars.</div>
<div>4. Sand off and level old gudgeon holes and put gudgeon back (10-15 min 2 people needed).</div>
<div>4a. Put inspection port lids back and secure them with a thin shock cord. </div>
<div>5. Clean and reseal a baler (1 hour work for 2 people)</div>
<div>6. Check the rig and replace ropes if necessary. </div>
<div>7. Put a missing eyelet on one of tasar's sails.</div>
<div>8. Fix the battens.</div>
<div> </div>
<div>Racing lasers. </div>
<div>8. Race II, sand a little bit gelcoated spots (if one wishes). </div>
<div>9. Race I, put a racing outhaul line.</div>
<div>10. Race II, completely change the rig on a racing one. </div>
<div>11. Put and adjast new duggerboard friction pads. </div>
<div> </div>
<div>Racing taser (optional work). </div>
<div>12. Take off old daggerboard gasket padding. </div>
<div><br>-- <br>Sincerely, <br>Alex Minovich.<br>PhD Student,<br>Nonlinear Physics Centre<br>Research School of Physical Sciences and Engineering<br>Le Couteur Building, Building 60<br>Mills Road, ANU, 0200 Australia<br>
T: 6125 9076<br>F: 6125 8588<br></div>